Technical tips: Tyre inflation and inner tubes fitting

Inflation

To carry out correct inflation on a central-locking tyre changer, position the tyre valve at 9 o’clock, avoid resting your hand on the tyre, and maintain a safe distance of 1.5 metres.

During inflation, the Scuola Nazionale Federpneus recommends:

  • Securely fastening the rim to the tyre changer. If the machine does not have a safety retention device, it is preferable to inflate the tyre in a safety cage or other retention device.
  • Never insert flammable substances inside the wheel assembly and take care not to ignite combustion in an attempt to seat the beads on the rim. This manoeuvre, besides being extremely dangerous, can cause hidden damage to the wheel assembly and therefore risks in motion.
  • Make sure the beads pass correctly and evenly over the rim humps when fitting tubeless tyres.
  • Do not exceed 330 kPa (3.3 bar/48 psi) in the seating (or jumping) pressure, to avoid damage or breakage of the bead. If the tyre does not seat at this pressure, release the air and check the cause of the failure, then repeat the procedure. Once the beads are correctly seated on the rim, the pressure can be increased to ensure proper and optimal seating of the wheel assembly. The “seating pressure” should not, however, exceed 400 kPa (4.0 bar/58 psi).

Guide to Fitting Inner Tubes in Tyres

First, it is necessary to determine whether an inner tube is suitable for the intended use. Tubeless tyres mounted on appropriate rims do not require inner tubes; however, there are some applications where users may choose to fit an inner tube, such as with a spoked rim or when using a tube-type tyre. It is important to remember that inner tubes must never be used as a means to repair a puncture in a tubeless tyre, as a proper repair is necessary to maintain the tubeless properties of the tyre.

Below are some guidelines for correct and safe fitting of inner tubes in tyres:

  • Always use a new inner tube when fitting a tyre.
  • Always use an inner tube marked with the corresponding size. If inner tubes of the correct size are not available, do not use a tube of a different size.
  • Before installing an inner tube in any tyre, carefully inspect the inside of the tyre to ensure there are no elements that could damage the tube. In particular, pay attention to paper or plastic identification labels (if present, these must be removed before fitting the inner tube), damage to the inside of the tyre, even from possible penetration or previous repairs, and foreign material (such as dirt or debris).
  • Replace the rim band when installing a new inner tube.
  • Pre-inflate new inner tubes to ensure that the tube is evenly installed inside the tyre cavity.
  • Ensure the air pressure is correct, as recommended by the tyre manufacturer or a professional tyre fitter.